Answer to Q#1
A transponder is a wireless communications, monitoring, or control device that picks up and automatically responds to an incoming signal.
Transponders are microwave repeaters located at intermediate points in a communications link, which are used to compensate for the signal attenuation along the route to extend the range of the link. They receive the very weak signals from a sender at one end of the link, amplify them, and re-transmit them at much higher power to the receiver at the other end of the link. The whole purpose of a communications satellite system is to place a transponder in position, to keep it there and to keep it powered up. Because of the very high launch costs, for satellite systems to be economically justified, the transponder should be able to carry high traffic volumes including television channels as well as dozens of multiplexed voice communications and other data links. It should also be small and light.
Questions: Marks 10
Question # 1 Marks 10
An organization has its satellite-based network that it provides direct broadcast services. This organization comes across signal attenuation problem due to the long distance communication links, which results in the poor service.
As a network engineer, what you will advise to that organization to compensate this attenuation?
Answer to Q#1
A transponder is a wireless communications, monitoring, or control device that picks up and automatically responds to an incoming signal.
Transponders are microwave repeaters located at intermediate points in a communications link, which are used to compensate for the signal attenuation along the route to extend the range of the link. They receive the very weak signals from a sender at one end of the link, amplify them, and re-transmit them at much higher power to the receiver at the other end of the link. The whole purpose of a communications satellite system is to place a transponder in position, to keep it there and to keep it powered up. Because of the very high launch costs, for satellite systems to be economically justified, the transponder should be able to carry high traffic volumes including television channels as well as dozens of multiplexed voice communications and other data links. It should also be small and light.
Answer to Q#2
Being a networking engineer, he should suggest the use of polynomial codes to the organization for desired objective.
The benefits of using polynomial codes is that it produces short codes. For example, here a 6-bit pattern is replaced by 3 terms.
In polynomial codes, the degree is 1 less than the number of bits in the binary pattern. The degree of polynomial is the highest power in polynomial. For example as shown in fig degree of polynomial x5 +x2 + 1 are 5. The bit pattern in this case is 6.
A pattern of Os and 1s can be represented as a polynomial with coefficient of o and 1.
Here, the power of each term shows the position of the bit and the coefficient shows the values of the bit.
For example, if binary pattern is 100101, its corresponding polynomial representation is x5 + x2 + 1. Figure shows the polynomial where all the terms with zero coefficient are removed and x J is replaced by x and XO by 1.
3928af59-bac2-4f9a-894d-945020ddd784-image.png 79341682-0cfb-44e4-ae5c-b71892910eb8-image.png
If you want to know how you can join us and get 100% Discount on your FEE ask Cyberian in Chat Room!
